ADC Cuda 12000 Informations techniques télécharger pdf (Page 200)

100

101

ADC Telecommunications, Inc.

196 CHAPTER 2: CUDA 12000 BASE SYSTEM COMMANDS

ip ospf cost

Configures the cost metric for the current OSPF interface. Note the following:

■ You execute this command from IP interface mode.

■ Once within this mode, you must specify the IP interface to which you want to apply the

OSPF configuration using the ip address command.

■ You must have already defined one or more ospf areas with the ospf area command within

router:ospf mode. You must apply an ospf area to the current interface using the ip ospf

area-id before you use this command.

■ Use the show ip ospf command to display the OSPF configuration for the current interface.

Mode

interface:<type>:csi(<c/s/i>):ip-address(<ip-address>)#

Syntax

ip ospf cost <cost>

Arguments

<cost> Cost that you want to assign to this OSPF interface. Valid range is 0 to

65535. The default is 1.

This value specifies the type of service (TOS) cost. The lowest TOS cost has the

highest priority for routing. For example, if two interfaces can be used to

forward traffic to the same destination, the one with the lower TOS cost is

selected.

1 2 ... 195 196 197 198 199 200 201 202 203 204 205 ... 651 652

Commentaires sur ces manuels

Pas de commentaire

ADC Cuda 12000 Informations techniques Page 200

Commentaires sur ces manuels

Produits connexes et manuels pour Commutateurs de réseau ADC Cuda 12000