ADC 1000 Instructions d'exploitation télécharger pdf (Page 10)

Using the ADC1000-USB: USB Mode

Configuring Data Acquisition

Select Spectrum > Configure Data Acquisition from the OOIBase32 menu bar to open the

Configure Data Acquisition screen.

From this screen, you can configure your data acquisition parameters such as integration time,

averaging, boxcar smoothing, and several other parameters.

Saving Wavelength Calibration Coefficients: USB Mode

You can store wavelength calibration coefficients unique to your S2000 Spectrometer on an

EEPROM memory chip on the ADC1000-USB. Once they are stored in memory, OOIBase32

reads the wavelength calibration coefficients. This feature is only available when using the

ADC1000-USB via the USB port.

Note: If you are using the ADC1000-USB via the serial port, proceed to the Saving Wavelength

Calibration Coefficients: Serial Mode section.

Perform the following steps to save wavelength calibration coefficients using the USB mode:

1. Make sure that the S2000 Spectrometer and ADC1000-USB are connected to your PC.

2. Open OOIBase32 and select Spectrometer > Configure from the menu bar.

ADC1000-USB Operating Instructions 7

(Continued)

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 26 27

Pas de commentaire

ADC 1000 Instructions d'exploitation Page 10