Adc PowerWorx Power Distribution Manuel d'utilisateur télécharger pdf (Page 10)

ADCP-80-575 • Issue 2 • December 2006

Page 4

1.4 Packaged Hardware

The fuse platform is shipped with hardware components (shown in Figure 2) that are packaged

separately and enclosed in the same carton. The packaged hardware components include the

following items:

• Two sets of mounting brackets (for 19-inch or 23-inch rack mounting)—Used to mount

the panel on the equipment rack.

• 5/16-inch long, Phillips drive, 8-32 flat-head thread-forming screws (8)—Used to secure

the mounting brackets to the panel.

• 3/8-inch long, combination drive, 12-24 pan-head screws (4) and #12 flat washers (4)—

Used to secure the mounting brackets to the equipment rack.

• #10 ring terminals (2) for 12–10 AWG wire—Used to connect the grounding cables to the

grounding studs.

• Rear protective input terminal covers and output terminal covers—Used to prevent

accidental contact with the power input and output terminals. The number of covers

provided depends on the fuse configuration.

• Designation card and card holder—Used to record information about the protected

equipment. The card holder has a pressure-sensitive adhesive backing to permit

attachment to the panel, the rack, or a location close to the panel. The designation card

inserts into the card holder. It is also available as an accessory item.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 39 40

Pas de commentaire

Adc PowerWorx Power Distribution Manuel d'utilisateur Page 10