ADC Megabit Modem 700F Manuel d'utilisateur télécharger pdf (Page 30)

Setting Up ADSL Service

20 Megabit Modem 400F, 500L, 600F, and 700F User Manual

SETTING UP ADSL SERVICE

The service provider sets up the ADSL parameters for your service. The modem must have

the ADSL SYNC LED lit before you can connect sessions with your service provider. Verify

SYNC in the following section, “Checking LED Indications.”

CHECKING LED INDICATIONS

The table below describes LED indications for all operational modes. LEDs on the modem front

panel provide continual status at-a-glance for network and modem connections.

LED State Description

PWR On green Modem has power.

Off Modem does not have power.

LAN

LINK On green A PC, hub, or other network device is connected to the modem

10/100BASE-T interface.

Off No device is connected to the modem 10/100BASE-T interface.

TX Flashing green Modem is transmitting data to devices on the LAN.

Off Modem is not transmitting data to the LAN.

RX Flashing green Modem is receiving data from devices on the LAN.

Off Modem is not receiving data from the LAN.

ADSL

SYNC On green ADSL transceiver is synchronized and in normal operation mode.

Flashing green ADSL transceiver is in a start-up sequence.

Off ADSL modem transceiver is not detecting a transceiver at the far end.

TX Flashing green Modem is transmitting data to the service provider.

Off Modem is not transmitting data to the service provider.

RX Flashing green Modem is receiving data from the service provider.

Off Modem is not receiving data from the service provider.

MAR On green ADSL margin is at or above the value set by the service provider.

Off ADSL margin is below the value set by the service provider.

OH On yellow Telephone receiver is off hook.

Off Telephone receiver is on hook.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 139 140

Pas de commentaire

ADC Megabit Modem 700F Manuel d'utilisateur Page 30