Adc SG-1 Manuel d'utilisateur télécharger pdf (Page 97)

June 30, 2006 Chapter 7: Second Level Commands

SG1-UM-8500-03 7-17

[loopback]

Places a logical loopback on the bridge-route interface.

Numeric value assigned to the bridge-route loopback.

[mtu]

Used to set the interface's Maximum Transmission Unit (MTU) (valid values are 1500 or 1544).

Example(s)

Using the pppoa enable command

This command enables PPPoA negotiation for a specific interface within the system.

Usage

pppoa enable interface <slot number>\<port number\[sub-interface number]>

Before enabling PPPoA, you must configure the correct port and the ATM interface.

Parameter(s)

Table 7-5. pppoa enable interface parameters

Example(s)

Host(config)# interface atm 2 \ 1 \ 1 type bridge-route point-to-point ip

192.168.10.1 255.255.255.0 mtu 1544

Added item

Host(config)#

Host(config)# pppoa enable interface

Parameter Description Legal values/range

<slot> Slot number. 1 - 2

<port number> Physical port number. 1 - 2

<sub-interface number> Sub-interface number. 1- 2000

Host(config)# pppoa enable interface 0 \ 1

1 2 ... 92 93 94 95 96 97 98 99 100 101 102 ... 225 226

Pas de commentaire

Adc SG-1 Manuel d'utilisateur Page 97